Alloy USA Jeep TJ/LJ 97-06 Dana 44 Rear Axle Shaft 33-Spline LH or RH
Alloy USA uses high strength 4140 Chromoly in all its Jeep® axles Our axles are heat-treated twice and induction hardened to produce these heavy-duty axles that are up to 35% stronger than stock 1040 axles. Alloy USA™ uses the latest cold spline rolling technology, to produce splines that are stronger than traditional cut splines. Our shafts are covered by an exclusive 10-year warranty! Rear axle shaft kits include everything you need for your installation: both passenger and drive side shafts, seals, bearings and wheel studs. and wheel studs.
Installation Requires (2+ Hours):
Write a reviewYour Name:
Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: